![]() You are better off just using a switched ignition +12V circuit, if you're just adding an amp or two. Remote is impossible without a CAN bus interface (there is no remote or switched ignition power at the radio, it's commanded on/off with CAN). Definitely look into the specifics though because I can't remember for sure. But I think if you ground the Bose pin, the front speaker outs become line level as well. The rear speaker outs are always line leve. If you also have Bose, I believe you have to do something with the Bose pin (or it could have been the otherway around-if you don't have Bose you have to do something with the pin.I can't remember now). You just have to convert them from wires to RCAs using a harness (like in your link) or some electrical skills Click to expand.Haven't done it but you have standard line outs in the harness/connector for the rear speaker outputs, which can be used to feed an amp. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |